ECO, Upgrade and Modification Services

View Full Size - 1 Minute

The world of electronics manufacturing is certainly fast paced. Engineering changes and upgradeS are a reality that need to be dealt with. Do you have the qualified rework technicians to do the job efficiently and reliably?

Our technicians are adept at a wide range of ECO procedures including surface mount and BGA component rework, adding jumper wires, cutting internal circuits and other intricate operations that require pinpoint accuracy and close tolerances.

Wires are often bonded using Flextac Wire Dots.

Refer to the following procedures for detailed information.

• Jumper Wires
• Jumper Wires, BGA Components, Circuit Track Method
• Jumper Wires, BGA Components, Through Board Method
• Circuit Cut, Surface Circuits
• Circuit Cut, Inner Layer Circuits
• Deleting Inner Layer Connection At A Plated Hole, Drill Through
• Deleting Inner Layer Connection At A Plated Hole, Spoke Cut

For prices on ECO and modification go to: Service Charges.

---

Jumper Wires

If your circuit board modification requires jumper wires we do those too. We routinely add Jumper Wires and cut circuits. We have a complete set of detailed illustrations covering jumper wire termination methods.

Intricate wire adds are a specialty at Circuit Technology Center.

---

Circuit Cuts

Engineering changes often require component leg lifts or the isolation of circuit patterns. Completing this task on today's dense and complex circuit board designs is challenging. Our team of technicians are experts at these difficult rework processes. We have several precision milling systems that provide pinpoint accuracy and exact depth control when cutting surface and internal circuits in dense areas.

Precision drill systems and milling machines are used for accurate circuit cuts.