Calibration Record CLR1007 Revision A  |   ECN53  |   Rev Date: Jan 11, 1995

Solder Reflow System (CLR1007, S# M0891110002/CS072)


Written By: C. Dennehy


Description
Solder Reflow System

Make/Model
Electrovert, Model Solda Pac, Serial#M0891110002/CS072

Calibration Interval
1 year

Next Calibration Due
Jan 15, 2009

Calibration Procedure
  1. To calibrate instrument, bring solder to operating temperature and allow sufficient time to stabilize; check that thermocouple is properly in well, then proceed as follows:
  2. If swiching does not occur within proper span (approx. 5 degrees F above and below zero) then the indicator needle must be adjusted.
  3. Remove unit from console by unscrewing removal screw and pulling instrument out of casing. Locate needle adjust screw and rotate needle in appropriate direction. Replace in casing and check results; repeat until desired accuracy is attained.
  4. To calibrate temperature, place an accurate thermometer in the solder wave and compare set point temperature with measured temperature. If there is a significant difference the R5 potentiometer must be adjusted.
  5. Rotate set point knob to measured temperature then remove unit from casing and rotate R5 screw clockwise to decrease temperature or counterwise to increase. Replace in casing and check results; repeat until desired accuracy is attained.
  6. Should unit fail to operate properly,  check for defective thermocouple; check wiring if necessary.


Calibration Log
Date Calibrated By Corrections
Jan 9, 1995 S. Moccia No corrections
Jan 19, 1996 S. Moccia No corrections
Jan 15, 1997 S. Moccia No corrections
Jan 15, 1998 E. Farnham No corrections
Jan 12, 1999 E. Farnham No corrections
Jan 21, 2000 N. Arrivella No corrections
Jan 7, 2001 N. Arrivella No corrections
Jan 9, 2002 N. Arrivella No corrections
Jan 18, 2003 R. Barrett No corrections
Jan 27, 2004  R. Barrett 

No Corrections, +/-7F ok per CD, see attached for solder sample analysis. 

Jan 05 E. Farnham/  N. Arivella No Corrections
Jan 05 E. Farnham No Corrections
 Jan, 12.2007  E. Farnham Unit meets specification.
 Jan 15, 2008  P. Vigneau   Unit meets specification.
     
     
     


Index